We Offer More Than A/C Inspection

We do factory recommended system maintenance, including up to 2 filters per system

 

Call us at (757) 630-7678!

See below for services that we offer – more than just A/C inspection!

FOR YOUR AIR CONDITIONER/HEAT PUMP

  • line voltage within range
  • low voltage within range
  • inspect contactor
  • clean contactor contacts
  • line voltage connections
  • low voltage connections
  • control board connections
  • test defrost control operations
  • changeover valve
  • compressor operation
  • capacitor UF value
  • refrigerant charge
  • condenser coil condition
  • vacuum primary drain line
  • entering water pressure
  • leaving water pressure
  • water pump operation
  • condenser is level
  • pressure port caps installed
  • line set insulation
  • fan blade
  • fan motor operation
  • electrical disconnect
  • thermostat wire insulation

FOR YOUR THERMOSTAT

  • confirm proper operation
  • firmly mounted
  • batteries replaced

FOR YOUR FURNACE/AIRHANDLER

  • unit duct work seal
  • inspect evaporator coil
  • clean drain line p-trap
  • TXV bulb insulation
  • coil temp sensors (TXV bulb)
  • inspect control board
  • inspect all electrical connections
  • measure line voltage
  • measure control voltage
  • inspect blower wheel
  • blower motor operations
  • run capacitor uf value
  • electric heat strips operation
  • inducer motor operation
  • pressure switches
  • safety switches
  • gas valve operation
  • inspect burners and heat exchanger
  • clean flame sensor
  • clean spark ignitor
  • clean 90% furnace drain
  • condensation pump operation

FOR YOUR HUMIDIFIER/AIRCLEANER/UV LIGHT

  • replace humidifer pad *
  • clean drain line
  • clean static charge points
  • clean prefilter
  • replace uv bulb *